MindPX Hardware

The MindPX series were created by AirMind®. Please refer to: http://mindpx.net

MindPX Controller

Quick Summary

The main hardware documentation is here.

MindPX is a new generation autopilot system branched from Pixhawk®, been revised in schematic and structure, and been further enhanced with new features to make un-manned vehicle more smart and more friendly to use.

MindPX increases total PWM output channels to 16 (8 main outputs + 8 aux outputs). This makes MindPX can support more complicated VTOL configurations and more fine control. It is especially meaningful for those FMU-V4 based flight controllers as MindPX implements main and aux output in one single FMU.

  • Main System-on-Chip: STM32F427
    • CPU: 32bits, 168 MHz ARM Cortex® M4 with FPU
    • RAM: 256 KB SRAM
    • 2MB Flash
    • ST Micro LSM303D 14 bit accelerometer/magnetometer
    • MEAS MS5611 barometer
    • InvenSense® MPU6500 integrated 6-axis sensors
  • Highlighted features:
    • CNC processed aluminum alloy case, light and solid
    • Built-in isolated IMU redundancy
    • Total 16 PWM output channel (8 main + 8 aux)
    • 1 extra I2C port for flow connection.
    • 1 extra USB port for companion computer connection (built-in UART-to-USB converter)
    • Exposed debug port for development

Quick Start

Mounting

MindPX Mounting

Wiring

MindPX Wiring 1

MindPX Wiring 2

Pin

MindPX Pinout

Num. Description Num. Description
1 Power 9 I2C2 (MindFLow)
2 Debug (refresh bootloader) 10 USB2 (Serial 2 to USB)
3 USB1 (refresh firmware) 11 UART4,5
4 Reset 12 UART1 (Telemetry)
5 UART3 (GPS) 13 CAN
6 I2C1(external compass) 14 ADC
7 TF card slot 15 Tricolor Light
8 NRF/SPI(Remote Control) 16 Looper

Radio Receiver

MindPX supports a wide variety of radio receivers (since V2.6) including: PPM/SBUS/DSM/DSM2/DSMX. MindPX also support FrSky® bi-direction telemetry D and S.Port.

For detailed Pin diagram, please refer to the User Guide.

How to build

Please follow Getting Started and Building the Code. The target for MindPX is nuttx_mindpx-v2_default:

make nuttx_mindpx-v2_default

Companion PC connection

MindPX has a USB-TO-UART Bridge IC on the board. A micro-USB to USB type A cable is used for the connection. Connect micro-USB end to the 'OBC' port of MindPX and USB type A end to companion computer.

And the max BAUD rate is the same with px4 family, which is up to 921600.

User Guide

The user guide is here.

Where to buy

MindRacer is available at AirMind Store on internet. You can also find MindRacer at Amazon® or eBay®.

Support

Please visit http://www.mindpx.org for more information. Or you can send email to [email protected] for any inquiries or help.

© PX4 Dev Team. License: CC BY 4.0            Updated: 2018-06-16 09:20:31

results matching ""

    No results matching ""